USER MANUALEnglishPro1030
1213Using the Pro1030’s default reference temperature and temperature coefficient (25 °C and 1.91%), the calculation is carried out as follows:Specifi
1415Next, use the up or down arrow keys to adjust the shut off time from 0 to 60 minutes. Press enter to save the new shutoff time. Next, highlight th
16177. ‘Calibration Successful’ will display for a few seconds to indicate a successful calibration and then the instrument will return to the Run sc
18195. Wait for the temperature reading to stabilize, then press enter to complete the calibration or press Cal to cancel. 6. ‘Calibration Successf
20217. If the calibration is unsuccessful, an error message will display on the screen. Press the Cal key to exit the calibration error message and r
2223Figure 9, data set saved.The instrument will display ‘Memory Full’ if all 50 data sets have been saved and you attempt to save another data set.
242513, and 15 becomes 14. The instrument will return to Data mode after erasing one data set. Select Erase All Data Sets and press enter to clear th
26271. Soak the sensor for 10-15 minutes in clean water containing a few drops of commercial dish washing liquid.2. GENTLY clean the glass bulb and
2829Symptom Possible SolutionInstrument will not calibrate pH or ORP; instrument displays “Calibration Over”, “Calibration Under”, or “Unstable Readin
3031SPECIFICATIONSThese specifications represent typical performance and are subject to change without notice. For the latest product specification i
Item #605182Rev A, January 2013For the latest version of this manual,visit ysi.com©2013 YSI Incorporated.The YSI logo is a registered trademarks of YS
3233DECLARATION OF CONFORMITYThe undersigned hereby declares on behalf of the named manufacturer under our sole responsibility that the listed product
34When placing an order please have the following available:1.) YSI account number (if available) 2.) Name and phone number 3.) Purchase Order or C
iFactory Default ...14Calibration ...
ii1THIS PAGE LEFT INTENTIONALLY BLANKINTRODUCTIONThank you for purchasing the YSI Pro1030, an instrument from the YSI Professional Series product fami
234. Install the new batteries, ensuring correct polarity alignment (figure 1).5. Place the battery cover on the back of the instrument and tighten
45iWhen an ISE sensor is not installed in the cable, the bulkhead connector is not water-proof. Do not submerge the cable without a sensor installed.
67BACKLIGHTOnce the instrument is powered on, pressing the power/backlight key will turn on the display backlight. The backlight will remain on until
89Figure 7, page 1 of System Setup menu. AUDIO Audio can be enabled by highlighting Audio and pressing enter. When enabled, there will be an ‘X’ in t
1011When Auto Stable is enabled, anAS symbol will display next to the reading on the Run screen and blink during stabilization. When the ISE and/or co
Commentaires sur ces manuels