Ysi Pro1030 Manuel d'utilisateur télécharger pdf (Page 8)

Figure 7, page 1 of System Setup menu.

AUDIO

Audio can be enabled by highlighting Audio and pressing enter. When

enabled, there will be an ‘X’ in the box next to Audio.

When Audio is enabled, the Pro1030 will beep twice to indicate stability

when Auto Stable is enabled. The instrument will also beep when a key

is pressed. When Audio is disabled, the Pro1030 will not beep.

CONTRAST

To adjust the display Contrast, use the up or down arrow keys to

highlight Contrast, then press enter. Next, use the up or down arrow

keys to adjust the contrast. The up arrow key will darken the contrast

and the down arrow key will lighten the contrast. After adjusting the

contrast, press enter to save and exit the Contrast adjustment function.

ALTERNATE CONTRAST ADJUSTMENT OPTION

If necessary, there is an alternate method of adjusting the contrast. To

adjust the contrast, press and hold the menu key, then press the up

arrow key to darken the contrast or press the down arrow key to lighten

the contrast.

TEMPERATURE UNITS

Highlight Temperature Units and press enter to open a submenu that

allows you to change the temperature units displayed on the Run

screen. Highlight the desired unit (Celsius or Fahrenheit) and press

enter to enable. The enabled temperature unit will have an ‘X’ in the

box next to it. Only one unit may be enabled at a time. Highlight the

ESC-Exit box and press enter to save any changes and to close the

Temperature Units submenu.

ISE SENSOR TYPE

ISE Sensor Type sets the type of ISE sensor being used; either pH

(model #1001) or ORP (model #1002).

Use the up or down arrow keys to highlight ISE Sensor Type, then press

enter to open a submenu. Highlight the sensor type corresponding

to the sensor installed on the cable and press enter to confirm. The

enabled sensor type will have an ‘X’ in the box next to it. Next, use the

down arrow key to highlight the ESC – Exit, then press enter to save

changes and to close the sensor submenu.

ISE UNITS

Highlight ISE Units and press enter to open a submenu that allows you

to select the ISE units to be displayed on the Run screen. Highlight a

unit and press enter to enable or disable it. An enabled ISE unit will

have an ‘X’ in the box next to it. Highlight the ESC-Exit box along the

bottom of the display and press enter to save any changes and to close

the ISE Units submenu.

When pH is enabled in the ISE Sensor Type menu, there are two

selectable measurement units: pH and pH mV. pH mV is the sensor’s

electrical measurement signal before being converting into pH

units. pH mVs can help you determine if you are performing a good

calibration and the condition of the pH electrode.

When ORP is enabled in the ISE Sensor Type menu, only ORP mVs can

be enabled as the ISE unit.

AUTO STABLE

Auto Stable utilizes preset values to indicate when a reading is stable.

The preset values are adjustable in the System Setup menu. The user

can input a % change in measurement reading over ‘x’ amount of time

in seconds. There are two separate Auto Stable controls, one for ISE

readings (ISE Auto Stable) and one for conductivity readings (Cond.

Auto Stable). ISE Auto Stable is located on the first page of the System

Setup menu. Cond. Auto Stable is located on the second page of the

System Setup menu.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Commentaires sur ces manuels

Pas de commentaire

Ysi Pro1030 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Ysi Pro1030