Ysi Pro1030 Manuel d'utilisateur télécharger pdf (Page 5)

4. Install the new batteries, ensuring correct polarity alignment

(figure 1).

5. Place the battery cover on the back of the instrument and

tighten the four screws. Do not over-tighten.

Figure 1. Pro1030 with battery cover removed. Notice

battery symbols indicating polarities.

The waterproof instrument case is sealed at the factory and

is not to be opened, except by factory-authorized service

technicians. Do not attempt to separate the two halves of the

instrument case as this may damage the instrument, break the

waterproof seal, and will void the warranty.

KEY PAD

Figure 2, Keypad

Number Key Description

Calibrate

Press and hold for 3 seconds to calibrate.

Opens Calibrate menu

from the Run screen.

Up Arrow

Use to navigate through menus, to

navigate through box options along

the bottom of the Run screen and

to increase numerical inputs.

Power and Backlight

Press once to turn instrument on. Press a

second time to turn backlight on. Press a

third time to turn backlight off. Press and

hold for 3 seconds to turn instrument off.

Press to enter the System Setup

menu from the Run screen.

Enter

Press to confirm entries and selections.

Down Arrow

Use to navigate through menus, to

navigate through box options at

the bottom of the Run screen and

to decrease numerical inputs.

CONNECTING THE SENSOR AND CABLE

“Bulkhead” refers to the single-pin connector at the end of the probe/

cable assembly where an ISE sensor, either pH or ORP, is installed

(figure 3). The conductivity and temperature sensors are located above

and next to the bulkhead and are not replaceable.

1 2 3 4 5 6 7 8 9 10 ... 20 21

Pas de commentaire

Ysi Pro1030 Manuel d'utilisateur Page 5